NSBon-15  «  NSBon accessories  «  IP-Surveillance  «  www.nsgate.com
NSGate. Be Sure.

Solutions and Applications
Outdoor access Nodes NSBox
Enclosures NSB-xxx
Accessories NSBon-xx
PoE Industrial Switches
PoE Injectors
PoE Extenders
Industrial SFP modules
Din-Rail Power Supplies

Ethernet over PDH/SDH
Ethernet over xDSL
Our new products

NSBox with embedded 4G LTE Router
NSBox-LTE | 4G LTE Routers

Explosion-proof enclosures
NSBox-4042E  Explosion-proof

PoE Extender NRP-172PRi
NRP-172PRi Extender | The best
Lightning and Surge protection of Ethernet ports
NSBon-15 | NSBon-14
NSBon-15  Brief
Optional Accessories NSBon-xx

Lightning and Surge protection of Ethernet ports > Up to 4 ports 10/100/1000Base-T > DIN rail mounting
> PoE 802.3af /3at /3bt/ 60W/ 95W > Compact design

  NSBon-15 and NSBon-14 are surge protectors keeping any IP devices with Ethernet 10/100/1000Base-T interface safe from lightning strike and other forms of electrical interference such as power surges and spikes over networking cables. The devices support PoE transmission in accordance with IEEE 802.3af/3at/3bt recommendations, regardless of the transmission method, as well as passive PoE.
  The NSBon-15 has eight shielded RJ45 Jacks for connecting four equipment ports. The NSBon-14 has two shielded RJ45 Jack for connecting one equipment port. These protectors utilize Gas Discharge Tubes (GDT) for each wire in RJ45 connector in order to protect all eight wires of networking cable including PoE. The “Line” sockets and the “Equipment” sockets of each port are located on different sides of the case opposite each other. There are also two contacts on the case, GND1 for connection directly to the potential equalization bus (PE) and GND2 for connection to a ground point inside the enclosure.
  The GND1 contact is electrically connected to the shields of sockets "Line". The GND2 contact is electrically connected to the shields of sockets "Equipment". Contacts GND1 and GND2 are galvanically isolated from each other.
  NSBon-15 and NSBon-14 are designed for DIN rail mounting and deployed beside PoE switches, inside junction boxes or electrical enclosures.
Ordering Information
NSBon-15Lightning and surge protection of 4x 10/100/1000Base-T Ethernet ports + PoE 802.3af/3at/3bt, indoor
NSBon-14Lightning and surge protection of 1x 10/100/1000Base-T Ethernet port + PoE 802.3af/3at/3bt, indoor

Technical Data
Maximum Operation DC Voltage: 60VDC
Impulse Discharge Current (8/20us) line-ground: 5 kA
Impulse Discharge Current (8/20us) line-line: 1 kA
DC Breakdown Voltage line-ground: 90 V
DC Breakdown Voltage line-line: 75 V
Up to 4 ports 10/100/1000Base-T + PoE
Input/ Output Connections: RJ45 shielded jacks
Mounting: clip for 35mm DIN Rail
Operating Temp.: -40 to +70°C
Dimensions: 115õ56õ40mm (NSBon-15)

Surge protector NSBon-15

Surge protector NSBon-15